Set rounded surface parameters

Set rounded surface parameters: the right half of the specified rounding Diameter, trim and stitching as well, and other options. The radius of the Examples of the trim 10 and the default, option is sutured to complete the results shown UG NX in Figure 3.22 (c ) Shown in Fig. 2) the use of overlapping edges to create a rounded surface shown in Figure 3.23 in the face of rounding, if you create two surfaces are tangent round, then by the length of the short side of Limit, the maximum can be done with a short length equal to the radius of the rounded surface. If you choose the short side as the outer boundary Faro coincides edge (, Coincident Edge), you can create a larger fillet radius (maximum can not exceed the long face side), but need Note that the inverted Forty five Rounded and short side will no longer tangent. Figure 3.23 coincide rounded edge surface (3) using the phase plane tangent to create a rounded surface rounding dialog FaroArm using phase control can be specified tangent Fillets in a plane tangent to the position, and set the radius of the way to "tangent constraint" that the system automatically determine the radius,