stretch until the next one

stretch until the next one (b) drawing up the selected object (c) stretching trimmed to two selected objects Figure 3.6 trimmed to stretch the boundaries of the object 2 with a bias pull The main purpose of the extension is to obtain the offset draw an UG NX equal wall thickness of the housing. When activated stretch bias option, you can specify two offset values and position as measured in section Baseline, as shown in Figure 3.7 (a) below. Figure 3.7 (b) represents the symmetric stretching bias. For the cross-section can also specify a closed unidirectional bias, as shown in 3.7 (c) as shown in . (a) bi-directional bias (b) symmetrically offset (c) Faro tensile bias unidirectional bias 3 Figure 3.7 with a draft angle of taper angle allows the specification of drawing is a side stretched material. Note that when the draw "start" position, and a cross-sectional drawing do not coincide, the draft angle needed to specify a reference position, including the "from the FaroArm starting position" and "the cross-sectional" two Manner, as shown in Figure 3.8 (a) (b), the two limits, respectively, when the drawing section is located at the sides,